EVT IR Glue Inspection with ThermoCare

With ThermoCare it can be fast and easily determined exactly at which position, which hot glue point should be applied and should be met with which temperature.

With just a few clicks it is precisely determined on any number of positions, which temperature they have and if the temperature is within the given threshold. Or if a temperature point (hot glue or heat source) exists at a determined region.

The ThermoCare is equipped with 8 in- and 8 outputs, which can be used to issue an IO/NIO signal for each position or group of positions, to report an error.

With the Profinet interface it becomes even easier. Via this interface the ThermoCare system can report any number of measurement points and also if there is an error value.

Via the OPC UA interface the ThermoCare systems can be integrated into the SCADA environment. So besides the direct communication with the PLC with Profinet, there is also the higher-ranking SCADA system to collect the measurement values for the latest process at the earliest possible stage.

The ThermoCare systems are based on the powerful EyeVision software. With the software not only hot glue points but also regions can be determined and monitored, but also temperature patterns can be monitored and tracked.

ThermoCare can be easily adapted to all applications, where a temperature or the presence or absence of a heat source has to be monitored.

ThermoCare systems are completely preconfigured and equipped with a suitable camera. Depending on the application the ThermoCare system is available either with cameras with 320x 240 pixel or with a high-resolution camera with 1024 x 768 pixel resolution.

Spread the love

Leave a Reply

Your email address will not be published. Required fields are marked *