EyeSens 3D Profile

EyeSens 3D Profile offers smart Profile Inspection completely without PC. The easy One-Button-Training of the integrated inspection surface of the EyeVision software has ready-made inspection programs. Therefore the user can start the inspection immediately without much configuration.

Brochure: EyeSens 3D Profile

EyeSens 3D Profile Features

Smart 3D Sensor – runs completely without PC; evaluation is carried out on the sensor
Compact hardware with FPGA and red or blue laser
Single-Button-Training of various profiles
Inspection for correctness of profiles with repeatable accuracy
Process Mode with ready-made application for Profile Inspection or
graphical user interface with drag-and-drop programming and the EyeVision 3D Profile command set
Possibility to integrate further inspections with the Single-Button-Training
Further ready-made applications for Bent-Sensor, Glue&Seal-Sensor, Gap-Sensor, etc. available

Available Sensors with EyeSens 3D Profile

EyeScan LTZ 3D sensor

The EyeScan LTZ 3D sensor is a compact and fast laser triangulation sensor with Dual-Core ARM processor and FPGA for...

EyeScan ST 3D sensor

3D laser triangulationssensor 3D sensor with profile speed of 3 kHz up to 6 kHz* Integrated FPGA and high-precision 3D...

Single-Button-Training Features

allows single-button-training of various profiles
Process Mode with ready-made applications for Profile Inspection
Pre-programmed profile inspection program
Easy-to-handle one-button-configuration of probes
One-button-setting of the EyeSens 3D Profile hardware
ProfileMatch available with all pre-configured commands

ProfileMatch for all programs

With each measurement command also the ProfileMatch can be activated. This means that a reference pattern is searched and compared with each captured image

Ready-made Application for EyeSens 3D Profile Inspection

Profile Inspection: Angle

Left and right probe setting for Angle Measurement Setting of the nominal value with plus and minus tolerances ProfileMatch can also be activated

Angle measurement in the Process Mode In case the angle is within the tolerances the overlay shows "good" in green color In case the angle is not within the tolerances the overlay shows "bad" in red color

Profile Inspection: Diameter

Setting of the Circle Probe for the Diameter Measurement Setting of the nominal value with plus and minus tolerances ProfileMatch has been activated, and a reference pattern configured

Diameter Measurement in the Process Mode In case the diameter is within the tolerances the overlay shows "good" in green color In case the diameter is not within the tolerances the overlay shows "bad" in red color The ProfileMatch detects the reference pattern in the captured profile

Profile Inspection: Height

Left and right probe setting of Height Measurement Setting of the nominal value with plus and minus tolerances ProfileMatch can also be activated

Height Measurement in the Process Mode In case the height is within the tolerances the overlay shows "good" in green color In case the height is not within the tolerances the overlay shows "bad" in red color The ProfileMatch has been activated and detects the reference pattern in the captured profile

Profile Inspection: Width

Setting of the left and right probe for the Width Measurement Setting of the nominal value with plus and minus tolerances ProfileMatch can be activated to configure a reference pattern

Width Measurement in the Process Mode In case the width is within the tolerances the overlay shows "good" in green color In case the width is not within the tolerances the overlay shows "bad" in red color The ProfileMatch is not activated. In case it is activated it detects the reference pattern in the captured profile